Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
parts:zero_position_sensors [2020/09/20 23:59] – user | parts:zero_position_sensors [2020/09/27 03:24] (current) – user | ||
---|---|---|---|
Line 5: | Line 5: | ||
===== Tower ===== | ===== Tower ===== | ||
- | The tower sensor is located under the hood in front of the tower pipe. The zero position is where the tower points straight ahead ([[: | + | The tower sensor is located under the hood in front of the tower pipe. The sensor detects a magnet that is mounted on the tower pipe. The zero position is where the tower points straight ahead ([[: |
===== Telescope ===== | ===== Telescope ===== | ||
- | The telescope sensor is located underneath the telecope protective sides at the back of the telescope. The zero position is where the tower is fully retracted. | + | The telescope sensor is located underneath the telecope protective sides at the back of the telescope. The sensor detects a magnet that is mounted on the [[: |
===== Arm ===== | ===== Arm ===== | ||
- | The arm sensor is located in the black box at the root of the arm. The zero position is where the arm is extended about 15 degrees from parallel to the boom ([[: | + | The arm sensor is located in the black box at the root of the arm. The sensor detects a magnet that is mounted inside the [[: |
===== Nozzle ===== | ===== Nozzle ===== | ||
- | The nozzle sensor is located inside the nozzle motor. The zero position is set where the nozzle points downwards when the arm is parked. However, this position depends on the angle the nozzle has been fastened with at the end of the arm. | + | The nozzle sensor |
===== Boom ===== | ===== Boom ===== |