Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
service:software [2021/05/17 01:34] – user | service:software [2021/12/13 02:24] – user | ||
---|---|---|---|
Line 5: | Line 5: | ||
[[: | [[: | ||
- | The latest software for the operator panel (PLC) is denoted **1.16**. The latest firmware is denoted **15.50**. | + | The latest software for the operator panel (PLC) is denoted **1.17**. The latest firmware is denoted **15.52**. |
The latest software for the control electronics (PCB) is denoted **1.22** (denoted 1.21 for older electronics revisions). | The latest software for the control electronics (PCB) is denoted **1.22** (denoted 1.21 for older electronics revisions). | ||
Line 13: | Line 13: | ||
===== PLC software change log ===== | ===== PLC software change log ===== | ||
- | ==== 1.16 (2021-05-17) ==== | + | ==== 1.17 (2021-09-22) ==== |
**New features** \\ | **New features** \\ | ||
Line 23: | Line 23: | ||
Feedback on notification feature termination\\ | Feedback on notification feature termination\\ | ||
Soft alarms are no longer flashed during automatic washing, but still found in alarm list\\ | Soft alarms are no longer flashed during automatic washing, but still found in alarm list\\ | ||
- | Hose spreader stops moving if hose reel has not moved for 5 s\\ | ||
Time limit for low water pressure alarm is increased to 120 s (from 30) | Time limit for low water pressure alarm is increased to 120 s (from 30) | ||
Line 83: | Line 82: | ||
===== PCB software change log ===== | ===== PCB software change log ===== | ||
- | ==== 1.22 (2021-03-19) | + | ==== 1.24 (2021-11-10) |
+ | |||
+ | Minor correction of hose reel standby control | ||
+ | |||
+ | ==== 1.22 (2021-03-19) ==== | ||
Faster start of hose reel motor | Faster start of hose reel motor | ||
Line 101: | Line 104: | ||
===== PLC firmware change log ===== | ===== PLC firmware change log ===== | ||
- | ==== 15.50 ==== | + | ==== 15.52 ==== |
- | Manufacturer fixed issue where it was possible for the unit to get stuck while booting which could result in complete backup battery drain if left unresolved \\ | + | Manufacturer fixed issue where it was possible for the unit to get stuck while booting which could result in complete backup battery drain if left unresolved\\ |
Manufacturer fixed issue where units were not shutting down properly when backup battery voltage was below 2.0 V | Manufacturer fixed issue where units were not shutting down properly when backup battery voltage was below 2.0 V | ||