Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
troubleshoot_repair_hose_spreader [2020/10/01 23:48] – joachim | troubleshoot_repair_hose_spreader [2020/10/02 00:05] (current) – joachim | ||
---|---|---|---|
Line 10: | Line 10: | ||
- The lid of the box is mounted with 4 screws, one screw is a bit tricky to remove but can be removed with a small flat chisel. Remove the grey plastic side of the robot to make more space while you work. \\ <font inherit/ | - The lid of the box is mounted with 4 screws, one screw is a bit tricky to remove but can be removed with a small flat chisel. Remove the grey plastic side of the robot to make more space while you work. \\ <font inherit/ | ||
- Due to vibrations in the robot, the connectors may jump of its place. To fix this we put a small amount of MS Polymer on the connector to hold it in place. \\ <font inherit/ | - Due to vibrations in the robot, the connectors may jump of its place. To fix this we put a small amount of MS Polymer on the connector to hold it in place. \\ <font inherit/ | ||
- | - Check the connector if you have power from the circuit board. | + | - Check the connector if you have power from the circuit board. |
- Once you have measured and checked if the hose spreader motor have power, you must check if moisture/ | - Once you have measured and checked if the hose spreader motor have power, you must check if moisture/ | ||
- You must seal all three entrences if this isn't done already. | - You must seal all three entrences if this isn't done already. |