User Tools

Site Tools

Trace: • Router • Screens • Zero position sensors • Troubleshoot/repair hose spreader

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
service:service_instructions:water_valve_cleaning [2021/04/05 23:52] – lars_enviroservice:service_instructions:water_valve_cleaning [2024/05/20 04:15] (current) – joachim
Line 15: Line 15:
 **2. **Unscrew the grey plastic side on the robot to get access to the 10mm hexagon screw. **2. **Unscrew the grey plastic side on the robot to get access to the 10mm hexagon screw.
  
-. {{:service:20210406_063627628_ios.jpg?nolink&300x400}}+. {{:service:20210406_063627628_ios.jpg?nolink&300x400|20210406_063627628_ios.jpg}}
  
 **3. **Dismount the 10mm hexagon screw like the picture below, and pull the plunge out. **3. **Dismount the 10mm hexagon screw like the picture below, and pull the plunge out.
Line 32: Line 32:
   * Make sure that the coil makes a click sound when mounted (press downwards).   * Make sure that the coil makes a click sound when mounted (press downwards).
  
-**7.**  Check and clean the small filter installed between the speed-connector and the hose (at the end of the hose). We also recommend to install a low-pressure filter before the high-pressure cleaner.+**7.**  Check and clean the small [[:service:spl:1105006|filter]] installed between the quick-connector and the hose (at the end of the hose). We also recommend to install a low-pressure filter before the high-pressure cleaner.